Kammprofile Gaskets

Kammpro style LP1

Kammpro style LP1 is manufactured without a guide ring for tongue and groove, or recessed flange applications such as Male and Female. It is typically used in heat exchanger applications and applied as an upgrade to double jacketed gaskets especially when lower load is needed. It is highly suggested to have the nubbin (if present) machined out when applying Kammpro LP1 in heat exchanger applications.

Kammpro style LP2

Kammpro style LP2 is constructed with an integral guide ring for aligning purposes. It is suggested to be used in raised face flanges. The sealing core is designed and sized per EN-12560-6 spec and depending on the flange specification the guide ring is sized to fit properly.

Kammpro style LP3

Kammpro style LP3 utilizes a loose fitting guide ring. This popular design is preferred to be used for nominal pipe size and pressure class raised face flanges and is used in equipment with excessive radial shear characteristics, thermal cycling, and expansions. The sealing core is designed per EN-12560-6 spec and the guide ring is sized to suit the flange specification.

Kammpro - HTG

Kammpro - HTG is recognized as a problem solver for heat exchangers, large vessels and equipment that experience high operating temperature. It utilizes a section of high performance mica/phyllosilicate that protects the graphite and shields it from contact of oxidizers. Kammpro HTG represents the best technology available in regards to torque retention and seal ability at elevated temperatures.

Kammpro ACHE

Kammpro ACHE is specially designed to replace traditional solid metal “washer” type gaskets typically used in air cooled heat exchangers. The design takes advantage of the serrated profile with graphite facing to bite against the finish of the header plate and fill in the voids, creating a superior level of tightness. The Kammpro-ACHE has proven to be a very viable solution to emission concerns found where optimal conditions for metal-to-metal sealing are not realized.

Kammpro Dual Seal

Kammpro Dual Seal mates with leak detection devices incorporated into flanged assemblies used in critical applications, such as lethal service. This highly effective gasket has a primary seal followed towards the outer portion of the sealing area by a relief section with through holes, where the leak detection equipment is mounted. Past this relief section is a secondary sealing area that will maintain the integrity of the bolted joint should the primary seal be compromised and pressure differential is identified.